AOMEI could not create a backup
Hello Everybody,
how are you ?? i hope you are all in a good health
i had created both Disk Full backup and incremental backup in last month (20 & 23 May) respectively that i had to restore them recently (which is done successfully )
today i tried to create incremental backup from the latest one but failed with error code 4123
how are you ?? i hope you are all in a good health
i had created both Disk Full backup and incremental backup in last month (20 & 23 May) respectively that i had to restore them recently (which is done successfully )
today i tried to create incremental backup from the latest one but failed with error code 4123
The specified volume 0 hasn't been found or has been changed.
The specified volume 1 hasn't been found or has been changed.
The specified volume 2 hasn't been found or has been changed.
The specified volume 3(C:) hasn't been found or has been changed.
Information Code:4123
All partitions that need to be backed up have not been found.
is there any way to fix that except deleting the backup and make full backup again as they were created for fresh windows 10 installation with build 1809 which will cost a lot of hassle to make it again and reconfigure all my application ??
Tagged:
Comments
if bug please provide a patch for it ASAP
i am really about to purchase a licence for pro version
I'm going back to 4.0.6 where I never had this issue...
That is not true I'm afraid.
Yesterday when testing this, I created a brand new full system backup. I then restored my system from this backup and once done, I tried using the same backup job to create an incremental backup based on the same full backup I just restored my system from. Which ended up with the error message described in the initial post in this thread.
I actually didn't remember, but I was active in this discussion in another thread in your forum as well. And that was even further back in time. Where you back in Sept 2018 said you would improve on this.
And here we are...still discussing the very same issue...this time only a couple of days from 2020...
You can find that other thread over here ->
https://www.aomeitech.com/forum/discussion/comment/12697#Comment_12697
P.S The version I tried yesterday was 5.5.0 and not 6.5.0. A typo on my part but maybe the version when we'll see this issue finally addressed D.S
And edited to add, yes...I always check the SSD Alignment option.
Happy New Year!